cufflinks

Complete the following steps: If you can see the leading edge of the paper is the paper and carefully pull out from the printer. If the paper is difficult to remove, then remove the paper jam. Remove the jammed paper, re-installed on the imaging drum and close the top cover. Clear the jam of the feed zone. Open Tray 2, in order to expose the cardboard. Complete the following steps: If the jam has been partially into the printer, clear a paper jam inside the printer. If the paper jam in the input tray, pull the edge of the jammed, pull it out. All paper in the tray re-alignment, then go to step 4. If you can not remove the jammed paper from inside the printer or from tray pulled out from the outside of the printer, grasp the jammed paper and carefully pull it out. The specific personnel should draft the drawing of green laser pointer 5mw.
Push down on the paper, the metal paper lift plate lock chamber in place (Tray 2) Slide the tray back into the printer. Clear the jam of the output area. Jams in these areas may result in loose toner on the printed page. If clothing or hands stained with toner, wash with cold water. (Hot water sets toner into fabric). Complete the following steps: from the top output bin could barely see the paper, then go to step 2. If you are almost ready to fully see the paper, then carefully pull out from the printer, and then go to the last step. Open the rear output door. If the leading edge of paper can be seen from the rear opening, it will pull out the paper and carefully. It is based on the basic knowledge of the laser technology of green laser pointer 5mw.
If the card sheets most of them into the printer, it is difficult to remove, then turn the printer off and unplug the power cord. Heating the rotation of the lock on the component to the open position. Grasp the fuser handle and pull out the fuser from the printer. Parts of the inner surface of the fuser is very hot. To avoid burning yourself, do not touch these parts. With both hands slowly, steadily remove all paper from the inside of the printer. Then, carefully re-load heating element and locked in place. Reconnect the power cord and turn on the printer. Print quality problems. Print light or faded. Vertical stripes appear on the page, the color is incorrect or faded areas. The paper may not meet the hp paper specifications (for example, the paper is too moist or too rough). Other parameters or performance of cheap Laser Pointers should be demonstrated.
One or more print cartridges are low. If you are using a non-hp print cartridge, the printer control panel or l500 hp color laserjet toolbox does not display any information. The imaging drum in the toner may be low or empty. Print the Supplies Status page to check the remaining life. If the toner in the imaging drum is low or empty, replace the imaging drum. Print toner cartridges and imaging drum are sufficient, in order to remove the print cartridge (one out a), check the toner in each cartridge roller is damaged. If damaged, replace the print cartridge. Toner spots. Paper may not meet specifications. For example, the paper is too moist or too rough. The abundant experience should be owned by the working personnel of green laser pointer 5mw.
The paper path might need cleaning. Pale area (usually circular) appear randomly on the page. This paper may be a problem. Try the print job again. The temperature of the paper is uneven or the paper surface water point. Try to use another sheet of paper, such as for the quality of the laser printer paper. See These poor paper quality. Manufacturing processes can cause some areas to reject toner. Try to use another brand of paper, such as for high-quality laser printer paper. The imaging drum may be defective. If these steps do not solve the problem, contact Customer Service. The vertical lines. Vertical stripes or bands appear on the page. One or more print cartridges are low or defective. Print the Supplies Status page to check the remaining life. They are in charge of the draft and preparation of green laser pointer 5mw.