cufflinks

Kodak 8100 Dry Laser camera to malfunction, repair two cases. After the boot of the failure phenomenon can not be self-test or through self-test after the film seized the arm can not be seized film from the film cartridge. Display the fault code: S04 the Stopped: P121 the Printer Error; P116 the Pickup Fail. Turn the camera on the back cover Analysis and Troubleshooting. Manual door control switch is closed. The seizure arm seizure action. Film to achieve the film feed axis. But can not enter the film to feed the region, along the drive shaft to fall back to the film cartridge, and then the machine stops working, the phenomenon of the failure to occur and the error code. Able to seize the film. May exclude the possibility of vacuum pump failure due to a larger workload. So the green green laser pointer 150mw is widely used in many occasions.
Above the rollers at both ends of lubrication. It obviously loose, and the failure to eliminate; ③ The the case of suspected failure of the drive roller motor (Feeder Roller Motor). The judgment method is to pinch the belt. Found rollers stopped. Replace the motor, the failure to eliminate; ④ replacement suction cups, so that the failure to eliminate. Kodak 1120 repair Fault phenomenon: a laser camera is not working properly, the machine screen displays an error code 10: FILM JAM,-named "SUPPLY". Maintenance analysis: According to the error code, check the manual: The jam occurred as the film was leaving the supply Magazine, area. Means that the photo card in the process of leaving the trays available. The better performance of  green laser pointer 150mw  has been achieved.
Machine reported from time to time in the course of the second regional cards: jam at area 2, opened the front door to put away the film, call the film normal, but after some time the same fault. The maintenance process: a laptop connected machine film transfer test found that most of the film to go to the piece normal, but often there will be a film from the pickup into a fee droller one end did not leaning feedroller suspected pickup problem, remove the pickup group found the group track the useful life of a very long wear very serious cause suction piece the wrong place and not be able to film put on the feedroller, so frequently appear jam at the area of fault 2. The customer can choose the suitable 150mw red laser based on the real needs and actual requirements.
Each loading box of the new film, the camera will start in accordance with this box of film quality conditions to adjust the density, contrast, and print out a test with all grayscale piece, in order to avoid the film due to the production batch, save the situation caused by the the end of the film in this fog difference to the image print quality. KODAK Dry view 8700 set the image contrast (Contrast) adjustment button of the maximum density (DMAX), contrast 1 to 15 levels of adjustment, the maximum density in the AIQC effective regulation of 1.70 ~ 3.10 in AIQC failure to provide a 16 levels of adjustment. Also set contrast, the density test (Contrast the Test Density Test) button. The green green laser pointer 150mw can be applied to many different locations.
(2) the failure reasons: ① the front door is closed, the cassette failed to open correctly. ② suction disc device failed to detect the cassette. (3) solution: ① detection open the cassette motor and on-chip box open position sensor (cartridge present sensor). The ② detect suction disc device is responsible for the down movement of the motor and is responsible for detecting cassette surface of the sensor (film s urface sensor). 2 Fault (1) failure phenomenon: Card in the Second District, Error Code: 21 l19 (2) Failure: ① suction disc device suck the film upward movement. Not the film completely into the one pair transfer. Roll axis (Feed Roller), the negative pressure of suction is lost. Film falling down, stick on a film magazine. Lead to absorption of films can not be sucked up again. Teaching baton is one of the most widely used applications of green laser pointer 150mw.